svn2git/libraries/pduino.git - pduino: converted automatically from sourceforge/svn

Age	Commit message (Collapse)	Author
2007-03-08	cleaned up for the Pduino 0.3 release	Hans-Christoph Steiner
	svn path=/trunk/externals/hardware/arduino/; revision=7476
2007-03-06	- got digital inputs working reading by port, sends only on change	Hans-Christoph Steiner
	- ignore Rx/Tx pins (0 and 1) since they are used for serial/USB - removed a fair amount of cruft svn path=/trunk/externals/hardware/arduino/; revision=7469
2007-03-05	- Removed lots of cruft and various attempts at fixing things.	Hans-Christoph Steiner
	- Removed timer2 interrupt code because it was interfering with the hardware PWM on some pins. Replaced it with timer0_overflow_count from wiring.c but that's not fully functional yet, I think I have to get the time units right. Right now it seems to just output everytime rather than every 4ms - removed second [arduino] object in arduino-test.pd that was causing lost serial data. WORKING - analog input working - hardware PWM output working - digital output working - setPinMode to INPUT/OUTPUT for digital pins working NOT WORKING YET - digital inputs - software PWM on non-hardware-PWM pins - save state to EEPROM svn path=/trunk/externals/hardware/arduino/; revision=7468
2007-02-22	- got analog input working	Hans-Christoph Steiner
	- version reporting works, but checkInput() isn't run enough, so it misses the data if there is a lot of traffic on the serial port svn path=/trunk/externals/hardware/arduino/; revision=7444
2006-10-31	added [digital 5 1( messages for digital input	Hans-Christoph Steiner
	svn path=/trunk/externals/hardware/arduino/; revision=6200
2006-10-31	got analog inputs converted to new message format, the foundation is laid ↵	Hans-Christoph Steiner
	for digital inputs... svn path=/trunk/externals/hardware/arduino/; revision=6197
2006-10-30	switched over to [digital 5 1( message format for output, . next for the ↵	Hans-Christoph Steiner
	hard part, switch over analog and digital to this message format svn path=/trunk/externals/hardware/arduino/; revision=6182
2006-09-29	added 'hardware' to the [import] so that [arduino] will load	Hans-Christoph Steiner
	svn path=/trunk/externals/hardware/arduino/; revision=6056
2006-09-15	redesigned the input protocol to be a 3-byte sequence, the first byte is the	Hans-Christoph Steiner
	data type, the second two are the data. The second two bytes are then combined to give one 14-bit value. For example 240 0 1 (from serial) == [version 1( (Pd message) arduino-test.pd was updated for this, the help patch was not, but should be largely correct. I only tightened up the layout of the help patch. svn path=/trunk/externals/hardware/arduino/; revision=5936
2006-09-04	switched to default to output mode so that you don't see voltage float on ↵	Hans-Christoph Steiner
	disconnected pins; changed test patch init settings to reflect initial state of arduino svn path=/trunk/externals/hardware/arduino/; revision=5865
2006-09-03	arduino-test.pd	Hans-Christoph Steiner
	svn path=/trunk/externals/hardware/arduino/; revision=5859